Set SMPP SMSC number

Set SMPP SMSC number SearchSearch
Author Message
Mihai Radu
New member
Username: Trepx

Post Number: 4
Registered: 06-2010
Posted on Monday, July 12, 2010 - 11:56 am:   

Hello,
How do I set the SMSC number when using SMPP connection? I did specify SMSC=number.. in the .ini file, but this setting is never sent (I did a packet capture).
Des - NowSMS Support
Board Administrator
Username: Desosms

Post Number: 2325
Registered: 08-2008
Posted on Monday, July 12, 2010 - 03:10 pm:   

Hi,

Setting the SMSC number like that is specific to modems only. When you use t hat setting you are telling the modem the address of an SMSC to connect to i n order to send the message.

This is not applicable for an SMPP environment.

-- Des
Mihai Radu
New member
Username: Trepx

Post Number: 5
Registered: 06-2010
Posted on Monday, July 12, 2010 - 03:30 pm:   

Thank you very much for your reply,
However, I need to be able to set the SMSC also for SMPP connection for my service provider since they allow that.
Des - NowSMS Support
Board Administrator
Username: Desosms

Post Number: 2328
Registered: 08-2008
Posted on Monday, July 12, 2010 - 06:11 pm:   

Hi,

You would need to ask your service provider what parameter they use for doing this. There is no standard parameter in the SMPP protocol for this.

SMPP is extensible in that providers can add additional parameters known as "TLV" parameters. If you can get details of the parameter format from your provider, then I might be able to assist.

--
Des
NowSMS Support