How to config SMPP for submit_sm | Search |
NowSMS Support Forums ⬆ NowSMS Support - MMS & Advanced Issues ⬆ Archive through June 09, 2011 ⬆ |
◄ ► |
Author | Message | |||
Ron Woods New member Username: Rmwoods Post Number: 2 Registered: 04-2010 |
We have a problem our SMSc only understands submit_sm not data_sm. How do I configure NowSMSc to send SMPP submit_sm format? | |||
Des - NowSMS Support Board Administrator Username: Desosms Post Number: 2068 Registered: 08-2008 |
By default NowSMS uses submit_sm, there is no configuration required. Data_sm is only used if WDP Adaptation is enabled for a connection. | |||
Ron Woods New member Username: Rmwoods Post Number: 3 Registered: 04-2010 |
so wdp can only be set to data_sm? | |||
Ron Woods New member Username: Rmwoods Post Number: 4 Registered: 04-2010 |
was my last question not understood? Just making sure that wdp is data_sm format only or can be modified for submit_sm? | |||
Des - NowSMS Support Board Administrator Username: Desosms Post Number: 2071 Registered: 08-2008 |
If WDP Adaptation is configured for a connection, then WAP push and other port addressed messages are submitted using data_sm. That is what the WDP Adaptation spec states. I am guessing that you are using this setting for a different purpose. It also has the side effect of submitting long messages in a single transaction. There is no way to configure the use of WDP Adaptation without it using data_sm for port addressed messages. Perhaps as an alternative you could not use WDP Adaptation but use TLV parameters for segmentation. (I am assuming that you are trying to avoid segmentation but I do not know why, perhaps it is because of UDH problems or garbled long messages, which can have other solutions.) (You seem very frustrated by the tone of your questions. Please consider that there are many different ways to use NowSMS, and with the limited details you have presented, I am having to guess about your configuration and intent.) -- Des NowSMS Support |